![]() ![]() But I put on't need to become restricted by one Sitting, so I asked yourself: I'll fix the verticality when I find a more permanent location for the dish.I'michael increasingly fascinated in Unicable techonology in order to possess (at least) the almost all used SAT in all réceivers. My mounting pole isn't particularly vertical (OK - is quite a way out) but this doesn't seem to be causing me any problems, probably because the dish I'm using is 60cm and thus its directionality is relatively weak. Note that I haven't tried reversing the 1/10 1/4 arrangement (ie having the receiver connected to a single 1/4 and this then connected to 4 (!!) 1/10 switches). I'm interested to see that I can get 28.2E perfectly well with a 60cm dish, and that the 60cm pointing directly at 5W gets a better signal than a multiconnect hanging off the end of the T-90 (although this is to be expected). Using this setup I have a lot of satellites doubled up. ![]() This means that I can zap between sats on the motorized LNB without inadvertently selecting one going through the rest of the diseqc switching setup and thus losing control of the motor. ![]() I've organized the satellites so I have the T-90 ones listed first, followed by all the motorized ones. When restarting I need to make sure that I'm pointing to a motorized sat otherwise when the box comes back up again looking at a non-motorized sat I'll lose control of the motor again. The tricky bit is this: if I select an LNB other than the motorized one I can no longer drive the motor (I still receive signal from the LNB from whichever satellite it happens to be pointing at) and have to restart the box to get it back. I have configured the sats on the motor as diseqc1.1 - 1 Cascade M1, port1 although it'll also work as 2 cascade port 1 or even diseqc 1.1 disable since I have it connected to port 1. Getting the motor to play nice was a little tricky. Note that I appear to have to put these switches on the 1/10 outputs numbered 8 or lower otherwise the receiver cannot select the correct LNB.Īn LNB switched via the 1/10 and a 1/4 is configured, for example, as Diseqc 1.0 port 2, Diseqc 1.1 2 cascade port 6. ![]() I have an Openbox S10, firmware as up to date as I can get it, attached to a diseqc 1/10 with the following outgoing connections:ġ - motorized 60cm dish - single black ultraĢ, 3, 4 - diseqc 1.0 1/4 switches and thence to the T-90. Note the green lines represent multiple connections (typically 3 or 4). This post is just a quick description of my setup in the hope that it will help someone else. ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |